Dell S6100, Configuration Manual

Page: 275 / 1743

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Related Commands
• set level — specify the OSPF area for route redistribution.
• set metric — specify the metric value assigned to redistributed routes.
• set metric-type — specify the metric type assigned to redistributed routes.
• set tag — specify the tag assigned to redistributed routes.
set comm-list delete
To remove the specified community list from the BGP route’s COMMUNITY attribute, configure a filter.
Syntax set comm-list community-list-name delete
To insert the community list into the COMMUNITY attribute, use the
no set comm-list community-
list-name delete
command.
Parameters
community-list-
name Enter the name of an established Community list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Access Control Lists (ACL) 275