Dell S4048T-ON, Configuration Manual

Page: 427 / 1146

show Show autoneg configuration information
Dell(conf-if-te-1/1-autoneg)# mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-te-1/1-autoneg)#
For details about the
speed
,
duplex
, and
negotiation auto
commands, refer to the Interfaces chapter of the Dell Networking OS
Command Reference Guide .
NOTE: While using 10GBASE-T, auto-negotiation is enabled on the external PHY by default, and auto-negotiation should be
enabled on the peer for the link to come up.
Adjusting the Keepalive Timer
To change the time interval between keepalive messages on the interfaces, use the
keepalive
command. The interface sends keepalive
messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command.
• Change the default interval between keepalive messages.
INTERFACE mode
keepalive [ seconds ]
• View the new setting.
INTERFACE mode
show config
View Advanced Interface Information
The following options have been implemented for the
show [ip | running-config] interfaces
commands for (only) stack-unit
interfaces.
When you use the
configured
keyword, only interfaces that have non-default configurations are displayed. Dummy stack-unit interfaces
(created with the
stack-unit
command) are treated like any other physical interface.
Examples of the
show
Commands
The following example lists the possible
show
commands that have the configured keyword available:
Dell#show interfaces configured
Dell#show interfaces stack-unit 1 configured
Dell#show interfaces tengigabitEthernet 1 configured
Dell#show ip interface configured
Dell#show ip interface stack-unit 1 configured
Dell#show ip interface tengigabitEthernet 1 configured
Dell#show ip interface br configured
Dell#show ip interface br stack-unit 1 configured
Dell#show ip interface br tengigabitEthernet 1 configured
Dell#show running-config interfaces configured
Dell#show running-config interface tengigabitEthernet 1 configured
In EXEC mode, the
show interfaces switchport
command displays only interfaces in Layer 2 mode and their relevant
configuration information. The
show interfaces switchport
command displays the interface, whether it supports IEEE 802.1Q
tagging or not, and the VLANs to which the interface belongs.
Dell#show interfaces switchport
Name: TenGigabitEthernet 3/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 3/2
802.1QTagged: True
Vlan membership:
Interfaces 427