Removing the Display Bezel
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the display assembly (see
Removing the Display Assembly
).
3.
Remove the six rubber screw-covers/display bumpers.
4.
Remove the two screw covers and the four shoulder screws.
5.
Remove the four M2.5 x 5-mm screws at the corners of the bezel.
6.
Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge (A) of
the display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear
the tab on the side (B) of the lower-right corner.
1 shoulder screws (4, two at the top and two at
the bottom)
2 screw covers
(2)
3 M2.5 x 5-mm
screws
(4, one on each
corner)
4 rubber screw-covers/display bumpers (6)
5 display bezel
CAUTION:
Before you begin the following procedure, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.
Summary of Contents for Precision M90
Page 8: ......
Page 14: ...Back to Contents Page ...
Page 41: ...Back to Contents Page ...
Page 46: ...Back to Contents Page ...
