Back to Contents Page
Display Assembly
Dell™ Precision™ M4300 Service Manual
Removing the Display Assembly
Removing the Display Bezel
Removing the Display Panel
Installing the Display Panel
Removing the Display Panel Brackets
Removing the Display Latch
Removing the Display Assembly
1.
Follow the procedures in
Before You Begin
.
2.
Remove the hinge cover (see
Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.
5.
Disconnect the antenna cable(s).
6.
Carefully remove the antenna cable and the display cables from their routing guides.
7.
Close the display.
8.
Turn the computer upside-down with the back of the computer facing you.
9.
From the bottom of the computer, remove the two M2.5 x 5-mm screws labeled "D."
CAUTION:
Before performing the following procedures, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
1
antenna cable
2
display cable pull-tab
