Dell PowerVault, Manual, Page: 283 / 396

nvsramBitSetting )]
[IPv4GatewayIP= ipAddress ]
[IPv6RouterAddress= ipv6Address ]
[iscsiHostPort [(0 | 1 | 2 | 3)] iscsiHostPortOptions ]
[rloginEnabled=(TRUE | FALSE)]
[serviceAllowedIndicator=(on | off)]
Parameters
Parameter Description
controller
The controller for which you want to define
properties. Valid controller identifiers are
0
or
1
,
where
0
is the controller in the top slot, and
1
is
the controller in the bottom slot. Enclose the
identifier for the controller in square brackets ([ ]). If
you do not specify a controller, the firmware for
the controller returns a syntax error.
availability The mode for the controller, which you can set to
online
,
offline
, or
serviceMode
(service).
ethernetPort
The attributes (options) for the management
Ethernet ports. The entries to support this
parameter are listed in the Syntax Element
Statement Data table that follows. Many settings
are possible, including setting the IP address, the
gateway address, and the subnet mask address.
globalNVSRAMByte
A portion of the controller NVSRAM. Specify the
region to be modified using the starting byte offset
within the region and the byte value or bit value of
the new data to be stored into the NVSRAM.
hostNVSRAMByte
The NVSRAM for the host-specific region. The
setting specifies the host index for the specific
host, the starting offset within the region, the
number of bytes, and the byte value or bit value of
the new data to be stored into the NVSRAM.
IPv4GatewayIP
The IP address of the node that provides the
interface to the network. The address format for
the IPv4 gateway is
(0–255).(0–255).(0–255).
(0–255)
IPv6RouterAddress The IP address of IPv6 router that connects two or
more logical subnets. The address format for the
IPv6 router is
(0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF): (0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF)
.
iscsiHostPort
This parameter enables you to set options for the
iSCSI ports on the controller. Select the specific
iSCSI port and then select the options for that port.
The iSCSI port identifier can be
0
,
1
or
2
,
3
. Refer
to the information about your controller for the
location and identifier of the ports.
The values that support this parameter are listed in
the Syntax Element Statement Data table that
follows. Many settings are possible, including
setting the IP address, the gateway address, the
283