Installing Enclosure Components
53
NOTICE:
RAID controller modules are hot-pluggable and can be removed and installed without shutting down the
enclosure. However, removing a controller module while data traffic is occurring that involves that controller could
cause data loss and is not recommended. Use the MD Storage Manager to take the RAID controller module off line
before removal.
NOTICE:
To prevent damage to your enclosure, you should wear a wrist grounding strap while performing the
following procedures. See your
Product Information Guide
for safety information.
1
Use MD Storage Manager to place the RAID controller module offline. See the MD Storage Manager
documentation for more information.
2
Remove the RAID controller module (see "Removing and Installing a RAID Controller Module" on
page 51).
3
Remove the screws holding the battery cover and remove the cover (see Figure 4-5).
Figure 4-5.
Removing and Installing a RAID Controller Module Backup Battery Unit
4
Unscrew the thumbscrew holding the battery unit to the controller module.
5
Disconnect the battery unit from the connector by sliding it towards the back of the controller, then
remove it from the controller module.
6
Place the replacement battery unit into the controller module tray and push the battery unit into the
connector on the RAID controller circuit board.
7
Tighten the thumbscrew to secure the battery unit to the controller.
1
thumbscrew
2
battery cover
3
battery unit
3
2
1
Summary of Contents for PowerVault MD3000
Page 68: ...68 Troubleshooting Your Enclosure ...
Page 100: ...100 Glossary ...
