Dell PowerVault 735N, Service Manual

Page: 34 / 88

Codes and Error Messages: Dell PowerVault 735N Systems Service Manual
file:///C:/Users/Phebega_Pericho/Desktop/spv735N/en/sm/beep.htm[3/15/2013 4:18:15 PM]
correction
code(ECC) on
disk read
Controller has
failed
subsystem or hard-disk drive
subsystem (defective system
board)
CD-ROM drive
not found
Improperly connected or
missing CD-ROM drive Check that the diskette drive/CD-ROM drive unit
is seated properly against the interposer board on
the peripheral cage. See "
Drives ."
CPUs with
different level
2 cache sizes
detected
Two different types of
microprocessors are installed Install a correct version of the microprocessor so
both microprocessors have the same level 2
cache size.
Data error
Faulty diskette, diskette drive,
or hard-disk drive Replace the diskette, diskette drive, or hard-disk
drive.
Decreasing
available
memory
One or more DIMMs
improperly seated or faulty Remove and reseat the DIMMs . If the problem
persists, replace the DIMMs .
Diskette drive
0 seek failure
Diskette drive
1 seek failure
Faulty or improperly inserted
diskette, incorrect
configuration settings in
System Setup program, loose
diskette/tape drive interface
cable, or loose power cable Check that the diskette drive/CD-ROM drive unit
is properly against the interposer board on the
peripheral cage. Run the System Setup program
to correct the diskette drive type. See "
Using the
System Setup Program ." Check the drive
interface and power cables.
Diskette read
failure
Faulty diskette, faulty or
improperly connected
diskette/tape drive interface
cable, or loose power cable Check that the diskette drive/CD-ROM drive unit
is properly against the interposer board on the
peripheral cage. See "
Drives ." Replace the
diskette-drive interface cable.
Diskette
subsystem reset
failed
Faulty diskette/tape drive
controller (defective system
board) Replace the system board .
Diskette write
protected
Diskette write-protect feature
activated Move the write-protect tab on the diskette.
Drive not ready
Diskette missing from or
improperly inserted in diskette
drive Reinsert or replace the diskette.
Embedded server
management
error
Embedded server
management is
not present
Embedded server
management memory may be
temporarily corrupted Shut down the system to clear the memory, and
then restart the system.
Gate A20
failure
Faulty keyboard controller
(defective system board) Replace the system board .
General failure
Operating system corrupted or
not installed properly Reinstall the operating system.