2
Introduction
This document provides basic information about the Dell PowerEdge FN 410S I/O Aggregator, including
how to install and perform the initial configuration. This document assumes the Dell PowerEdge FX2
server chassis is installed correctly. For the complete installation instructions, refer to the Dell PowerEdge
FX2 server chassis Installation Guide .
For information about how to configure and monitor switch features, refer to the
Configuration Guide for
the Dell PowerEdge FN 410S I/O Aggregator
, which is available on the Dell Support website at
.
Product Description
The aggregator is a multi layer, 12x10Gigabit Ethernet switch that operates in a Dell PowerEdge FX2
server chassis, which can support up to eight servers and two aggregator switches with four uplink
interfaces each.
The Dell PowerEdge FX2 server chassis is managed by a single chassis management controller (CMC),
which is similar to the CMC unit on the Dell PowerEdge M1000e and provides management connectivity
to two I/O Modules and the iDRAC units of all eight servers.
Introduction
7
