Figure 45. Installing a 1.8-inch SSD blank
1.
SSD blank
2. release latch
Shutdown procedure for servicing a hard drive or SSD
NOTE: This section applies only to situations where the sled must be powered down to service a
hard drive or SSD.
If you need to service a hard drive or SSD, turn off the sled and before removing the hard drive or SSD
wait for 30 seconds after the sled indicator turns off. Otherwise, the hard drive or SSD may not be
recognized after it is reinstalled and the sled is turned on again.
Configuring the boot drive
The drive or device from which the system boots is determined by the boot order specified in the System
Setup.
Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD
carrier
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Follow the safety guidelines listed in safety instructions section.
2.
Keep the Phillips #1 screwdriver ready.
1.
Remove the four screws from the slide rails on the hard drive or SSD carrier.
2.
Slide the hard drive or SSD out of the hard drive or SSD carrier.
103
