3.
Install the sled into the enclosure.
4.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Removing a sled
Removing the 1.8-inch solid state drive
Installing the 1.8-inch solid state drive carrier
Installing the 1.8-inch solid state drive
Installing a sled
After working inside your system
Installing the 1.8-inch solid state drive carrier
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
Remove the sled from the enclosure.
4.
Remove the 1.8-inch solid state drive (SSD).
5.
Keep the Phillips #2 screwdriver ready.
Steps
1.
Align the screws on the SSD carrier with the holes on the sled.
2.
Using the Phillips screwdriver, fasten the two captive screws to secure the carrier to the sled.
76
Summary of Contents for PowerEdge C6320p
