Figure 20. Removing a sled
Next steps
1.
Install the sled or sled blank into the enclosure.
2.
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing a sled
After working inside your system
Installing a sled
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support
team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
1.
Follow the safety guidelines listed in the Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
3.
If installed, remove the sled blank from the enclosure.
NOTE: The process to remove the sled blank is the same as removing a sled.
4.
Keep the Phillips #2 screwdriver ready.
Steps
1.
Slide the sled into the enclosure until it locks into place.
2.
Replace the screw that secures the retaining latch.
66
Summary of Contents for PowerEdge C6320p
