Dell PowerEdge 1-U Keyboard Tray, Installation Manual

Page: 12 / 90

1-10
Installation Guide
www
.dell.com | support.dell.com
2
Push the slide assembly forward until the mounting hook enters its respective square hole on
the vertical rail, and then push down on the mounting-bracket flange until the mounting
hooks seat in the square holes and the push button pops out and clicks. See Figure 1-4.
Figure 1-4. Installing the RapidRails Slide Assemblies
3
At the back of the cabinet, pull back on the mounting-bracket flange until the mounting
hooks are located in their respective square holes, and then push down on the mounting-
bracket flange until the mounting hooks seat in the square holes and the push button pops
out and clicks.
4
Repeat step 1 through step 3 for the slide assembly on the other side of the rack.
NOTE:
Ensure that the rails are mounted at the same position on the vertical rails on each side
of the rack.
front of rack
slide assemblies (2)
mounting hook
push button
mounting-bracket flange
support tab
hole for optional screw
10-32 x 0.5-inch flange-head Phillips screws and centering
washers (2 sets per slide assembly); optional