Activating the Dell PERC 3/Di
1-3
3
Align the memory module's edge connector with the slot in the center of the memory
module socket, and insert the memory module into the socket (see Figure 1-2).
The memory module socket has two alignment keys that allow you to install the
memory module in the socket in only one way.
NOTE:
The RAID controller memory module must be an unbuffered memory module, rated
to run at 100 MHz or faster. Do not substitute registered memory modules such as those
used for system memory.
4
Press the memory module with your thumbs while pulling the ejectors with your index
fingers to lock the memory module into the socket (see Figure 1-2).
F i g u r e 1 - 2 . I n s t a l l i n g a M e m o r y M o d u l e
5
Examine the RAID hardware key (see Figure 1-3) to ensure that it is labeled for your
system.
Hardware keys intended for use in other systems will not enable the RAID controller.
6
If the key is the correct type, install the key in its socket on the system board
(see Figure 1-1) and secure the key with the latches on each end of the socket
(see Figure 1-3).
alignment keys (2)
memory module
socket ejectors (2)
Summary of Contents for PERC 3/Di
Page 1: ...www dell com support dell com Dell Systems ACTIVATING THE DELL PERC 3 DI ...
Page 9: ...www dell com support dell com Systèmes Dell ACTIVATION DE DELL PERC 3 DI ...
Page 17: ...www dell com support dell com Dell Systeme DELL PERC 3 DI AKTIVIEREN ...
Page 25: ...www dell com support dell com Sistemas Dell ACTIVACIÓN DE DELL PERC 3 DI ...