Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
3. Connect the fingerprint-reader board cable to the connector on the I/O board and close the latch (if applicable).
4. Connect the I/O board power cable to the connector on the I/O board and close the latch.
5. Close the hinge and replace the two (M2x3.5) screws that secure the display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Install the
.
After working inside your computer
.
Speakers
Removing the speakers
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
About this task
The following images indicate the location of the speakers and provide a visual representation of the removal procedure.
40
Removing and installing components
Summary of Contents for P152G
Page 14: ...About this task 14 Removing and installing components ...
Page 16: ...About this task 16 Removing and installing components ...
Page 45: ...Removing and installing components 45 ...
Page 50: ...50 Removing and installing components ...
