Dell Networking S6000 System, Reference Manual

Page: 610 / 1510

Usage
Information Querier normally sends some group-specific queries when a
leave
message is
received for a group prior to deleting a group from the membership database.
There may be situations when you require immediate deletion of a group from the
membership database. This command provides a way to achieve the immediate
deletion. In addition, this command provides a way to enable
immediate-leave
processing
for specified groups.
ip igmp last-member-query-interval
Change the last member query interval, which is the Max Response Time inserted into Group-Specific
Queries sent in response to Leave Group messages. This interval is also the interval between Group-
Specific Query messages.
S6000
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, use the
no ip igmp last-member-query-
interval
command.
Parameters
milliseconds Enter the number of milliseconds as the interval. The range is
from 100 to 65535. The default is
1000 milliseconds .
Defaults 1000 milliseconds
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
E-Series legacy
command
610
Internet Group Management Protocol (IGMP)