Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults
Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1
Introduced on the Z9000.
Version 8.3.7.0
Introduced on the S4810.
Version 7.8.1.0
Introduced on the S-Series.
Version 7.7.1.0
Introduced on the C-Series.
Usage
Information
When you create a peer group, it is disabled (Shut mode).
Related
Commands
neighbor peer-group (assigning peers)
— assigns routers to a peer group.
— assigns a indirectly connected AS to a neighbor or peer
group.
— disables a peer or peer group.
neighbor peer-group passive
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message,
but responds to one.
S6000
Syntax
neighbor
peer-group-name
peer-group passive [
sessions
]
To delete a passive peer-group, use the
no neighbor
peer-group-name
peer-group passive
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
376
Border Gateway Protocol
Summary of Contents for Networking S6000 System
