switchport
To view the interfaces in Layer 2 mode, enter the
show interfaces switchport
command in EXEC
mode.
Accessing the System Remotely
You can configure the switch so that it can be accessed remotely over a Telnet connection.
The C9010 system has a dedicated management port and a management routing table that is separate
from the IP routing table. To configure the system for Telnet access:
1.
Configure an IP address for the management port.
2.
Configure a management route with a default gateway.
3.
Configure a user name and password.
Configuring the Management Port IP Address
To access the system remotely, you must assign IP addresses to the management ports.
NOTE: Assign different IP addresses to each RPM management port.
1.
Enter INTERFACE mode for the Management port.
CONFIGURATION mode
interface ManagementEthernet 0/0
2.
Assign an IPv4 or IPv6 address to the interface.
INTERFACE mode
ip address {
ipv4-address
|
ipv6- address
}/
mask
•
ip-address
is an address in dotted-decimal format (A.B.C.D).
•
mask
is a subnet mask in /prefix-length format (/ xx).
3.
Enable the interface.
INTERFACE mode
no shutdown
Configuring a Management Route
Define a path from the system to the network from which you are accessing the system remotely.
Management routes are separate from IP routes and are only used to manage the system through the
management port.
• Configure an IPv4 or IPv6 management route to the network from which you are accessing the
system.
CONFIGURATION mode
management route {
ipv4-address
|
ipv6-address
}/
mask gateway
–
ip-address
is the network address in dotted-decimal format (A.B.C.D).
–
mask
is a subnet mask in /prefix-length format (/ xx).
–
gateway
is the next hop for network traffic originating from the management port.
46
Configuring the Software
REGULATORY
DRAFT
11-4-14
