Dell N1100-ON, Reference Manual

Page: 927 / 2332

Security Commands
927
User Guidelines
If only one RADIUS server is configured, it is recommended that the
deadtime interval be left at 0. If a RADIUS server is currently active and
responsive, that server will be used until it no longer responds. RADIUS
servers whose deadtime interval has not expired are skipped when searching
for a new RADIUS server to contact.
Example
The following example sets the minimum interval for a RADIUS server will
not be contacted after becoming unresponsive.
console(config)#radius-server deadtime 10
radius-server host
Use the radius-server host command to specify a RADIUS server host and
enter RADIUS Server Configuration mode. To delete the specified RADIUS
host, use the no form of this command.
Syntax
radius-server host [ acct | auth ] {ip–address | hostname}
no radius-server host [ acct | auth ] {ip–address | hostname}
• acct | auth —The type of server (accounting or authentication).
• ip–address—The RADIUS server host IP address.
• hostname —Host name of the RADIUS server host. (Range: 1–255
characters).
Default Configuration
The default server type is authentication. The default server name is Default
RADIUS Server . The default port number is 1812 for an authentication
server and 1813 for an accounting server.
Command Mode
Global Configuration mode