Figure 10. Removing and installing a hard drive into a 3.5-inch hard disk drive carrier
1.
screws (4)
2.
hard disk drive
3.
hard disk drive carrier
Installing a hard disk drive into a hard disk drive carrier
1.
Insert the hard disk drive into the hard disk drive carrier with the connector end of the hard disk drive
at the back.
2.
Align the screw holes on the hard disk drive with the back set of holes on the hard disk drive carrier.
When aligned correctly, the back of the hard disk drive is flush with the back of the hard disk drive
carrier.
3.
Install and tighten the four screws to secure the hard disk drive to the hard disk drive carrier.
Enclosure Management Module
An enclosure with redundant enclosure management contains two enclosure management modules
(EMM). You can cable your enclosure either in a single port, redundant mode or in a multi-mode
configuration. If only one EMM is installed in your enclosure, it must be installed in EMM 0. You must
install the EMM blank in EMM 1.
NOTE: EMMs can be removed and installed without turning off the enclosure.
CAUTION: It is recommended that you do not remove an EMM while data is being transferred.
CAUTION: Replacing or installing an EMM that is connected to a host server causes it to end
communication with the enclosure and requires a restart of the host server.
16
