Dell Latitude 5490, Service Manual

Page: 42 / 105

2. Slide the camera assembly on the middle frame, and align the screw holes on the camera assembly with the screw holes on
the middle frame.
3. Replace the two screws (M3x5) to secure the camera assembly to the middle frame.
4. Connect the camera cable to the system board.
5. Align the screw holes on the camera door with the screw holes on the display-assembly base.
6. Replace the two screws (M3x5) to secure the camera door to the display-assembly base.
Next steps
1. Install the system-board shield .
2. Install the back cover .
3. Install the cable cover (optional).
4. Install the stand .
5. Follow the procedure in After working inside your computer .
Bottom cover
Removing the bottom cover
Prerequisites
1. Follow the procedure in Before working inside your computer .
2. Remove the stand .
3. Remove the cable cover (optional).
4. Remove the back cover .
5. Remove the system-board shield .
About this task
The following image indicates the location of the bottom cover and provides a visual representation of the removal procedure.
42 Removing and installing components