c Release the speakers from the tablet [3].
NOTE:
The speaker is attached with an adhesive, ensure to pull gently for reuse of the tape in installing the speaker.
Installing speaker
1
Insert the speaker in the block on the system board.
2
Connect the cables to the system board.
3
Press the speaker to glue it to the adhesive paste on the system.
4
Install the:
a
b
NOTE:
uSIM card is installed only on tablets shipping with WWAN module.
5
Follow the procedure in
After working inside your tablet
.
Battery
Removing the battery
1
Follow the procedure in
Before working inside your tablet
2
Remove the:
a
NOTE:
uSIM card slot is available only on tablets shipping with WWAN module.
b
3
To remove the battery:
a Release the adhesive tape that secures the battery connector to the system board.
b Disconnect the battery cable from the connector on the system board.
NOTE:
Ensure to pull the cable by the lever of the battery connector, to avoid damage to the pin.
c Remove the M2.0 x 4.0 screws (4) that secure the battery to the tablet [1].
d Lift the battery from the tablet [2].
18
Removing and installing components
Summary of Contents for Latitude 5290 2-in-1
Page 1: ...Latitude 5290 2 in 1 Owner s Manual Regulatory Model T17G Regulatory Type T17G002 ...
Page 45: ...Disk driver Figure 4 Disk driver Technology and components 45 ...
Page 47: ...Storage controller drivers Figure 6 Storage controllers Technology and components 47 ...
Page 82: ...82 Software ...
