Installing system board
1
Align the system board with the screw holders on the palm rest assembly.
2
Replace the M2.0x3.0 screws to secure the system board to the palm rest assembly.
3
Connect the display cable to the connector on the system board.
4
Place the metal bracket over the connector, and tighten the M2.0x3.0 screws to secure the display cable to the system board.
5
Connect the WLAN cables.
6
Place the metal bracket on the WLAN card, and tighten the M2.0x3.0 screw to secure the WLAN cable on the WLAN card.
7
Place the metal bracket on the system board and tighten M2.0x3.0 screws to secure on the system board.
8
Connect the following cables:
a power connector cable
b touchpad cable
c keyboard cable
d speaker cable
e audio cable
f
coin cell battery cable
g camera cable
9
Install the:
a
b
c
d
10 Follow the procedure in
After working inside your computer
.
Display assembly
Removing display assembly
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
c
3
To remove display cable:
a Remove the screws M2.0x.30 and lift the metal bracket that secures the display cable on the computer [1, 2].
b Lift the latch, and disconnect the display cable on the system board [3].
Removing and installing components
21
