Installing base cover
If the system is shipped with M.2 SSD perform the following steps.
1
Toe in the base cover front edge into the system.
2
Press the edges of the cover until it clicks into place.
3
Replace the M2.5x7 screws to secure the base cover to the computer.
4
Install the
5
Follow the procedure in
After working inside your computer
.
Battery
Removing battery (optional)
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
3
To remove the battery:
a Disconnect the battery cable from the connector on the system board [1,2].
b Remove the M2.0x3.0 screws that secure the battery to the computer [3].
c Lift the battery away from the computer [4].
10
Removing and installing components