c. Lift the hard drive assembly away from the computer [3].
NOTE:
The image displayed above is for reference only. Some components location may vary.
Installing the hard drive assembly
NOTE:
7mm SATA drive requires a 68Whr battery.
1. Insert the hard drive assembly into the slot on the computer.
2. Tighten the screws to secure the hard drive assembly to the computer.
3. Connect the hard drive cable to the connector on the hard drive and on the system board.
4. Install the:
a.
b.
5. Follow the procedures in
After working inside your system
.
Coin-cell battery
Removing the coin cell battery
Before working inside your computer
.
2. Remove the:
a.
b.
c.
3. To remove the coin cell battery:
a. Disconnect the coin cell battery cable from the connector on the system board [1].
b. Pry the coin cell battery to release from the adhesive and lift it away from the system board [2].
16
Disassembly and reassembly
