Replacing the Speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
NOTE: The rubber grommets may get pushed out while replacing the
speakers. Ensure that the rubber grommets are in their position after
placing the speakers on the computer base.
1
Using the alignment posts on the computer base, place the speakers on
the computer base.
2
Replace the rubber grommets if they are pushed up while replacing the
speakers.
3
Route the speaker cable through the routing guides on the computer
base.
Post-requisites
1
2
3
.
4
.
5
6
.
7
.
8
9
.
10
.
87
Summary of Contents for Inspiron 14 7000 Series
