Removing the status-light
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance
.
Prerequisites
1
Remove the
2
Remove the
Procedure
1
Open the latch and disconnect the status-light board cable from the
keyboard daughter-board.
2
Peel off the tape that secures the speaker cable to the palm rest and
keyboard assembly.
43
Summary of Contents for Inspiron 13 5000 Series 2-in-1
