Dell Force10 TeraScale C Series, Reference Manual

Page: 1283 / 1640

Security | 1283
privilege level (CONFIGURATION mode)
c e s
Change the access or privilege level of one or more commands.
Syntax privilege mode { level level | reset }
To delete access to a level and command, use the no privilege mode level level command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Use the enable password command to define a password for the level to which you are assigning
privilege or access.
privilege level (LINE mode)
c e s
Change the access level for users on the terminal lines.
Syntax privilege level level
To delete access to a terminal line, use the no privilege level level command.
Parameters
Defaults level
= 15
Command Modes
LINE
mode Enter one of the following keywords as the mode for which you are controlling access:
•
configure
for the CONFIGURATION mode
•
exec
for the EXEC mode
•
interface
for the INTERFACE modes
•
line
for the LINE mode
•
route-map
for the ROUTE-MAP
•
router
for the ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER BGP
modes.
level level
Enter the keyword
level
followed by a number for the access level.
Range: 0 to 15.
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes and commands.
reset
Enter the keyword
reset
to return the security level to the default setting.
command Enter the command’s keywords to assign the command to a certain access level. You can
enter one or all of the keywords
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
level level
Enter the keyword
level
followed by a number for the access level.
Range: 0 to 15.
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes.