Z9432F-ON switch installation
To install the Z9432F-ON switch, complete the installation procedures in the order given.
Always handle the switch and its components with care. Avoid dropping the switch or any field replaceable units (FRUs).
NOTE:
ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap
when handling the switch and its components. As with all electrical devices of this type, take all the necessary safety
precautions to prevent injury when installing this switch.
Topics:
•
•
•
•
•
•
•
•
Unpack
NOTE:
Before unpacking the switch, inspect the container and immediately report any evidence of damage.
When unpacking the Z9432F-ON switch, ensure that the following items are included:
●
One Z9432F-ON switch
●
One RJ45 to DB-9 female cable
●
Two sets of rail kits, no tools required
●
Two PSUs
●
Seven fan units
●
Two country- and region-specific AC power cables
●
Dell EMC PowerSwitch Z9432F-ON Set-up Guide
●
Safety and Regulatory Information
●
Warranty and Support Information
1. Place the container on a clean, flat surface and cut all straps securing the container.
2. Open the container or remove the container top.
3. Carefully remove the switch from the container and place it on a secure and clean surface.
4. Remove all packing material.
5. Inspect the product and accessories for damage.
Ground cable
To attach a ground cable to the switch, you need one of the included M4 screws.
NOTE:
For AC-powered switches, although the third conductor of the AC power cable provides a ground path, Dell
Technologies recommends grounding your switch with a dedicated ground wire.
NOTE:
For DC-powered switches, the only way to safely ground your switch is to attach a dedicated ground wire.
The switch configuration is two threaded holes using one of the two included M4 screws.
3
Z9432F-ON switch installation
9
