Upgrade Dell EMC Networking N3000E-ON Switches
Page 8
10.
Verify the stack of N3000E-ON Series and N3000 Series switches via
show switch
and
show version
command output like below:
Console#show switch
Management Standby Preconfig Plugged-in Switch Code
SW Status Status Model ID Model ID Status Version
--- ---------- --------- ------------- ------------- ------------- -----------
1 Stack Mbr Oper Stby N3048P N3048P OK 6.5.3.6
2 Mgmt Sw N3048EP-ON N3048EP-ON OK 6.5.3.6
3 Stack Mbr N3048EP-ON N3048EP-ON OK 6.5.3.6
4 Stack Mbr N3048P N3048P OK 6.5.3.6
Console#show ver
Machine Description............... Dell EMC Networking Switch
System Model ID................... N3048EP-ON
Machine Type...................... Dell EMC Networking N3048EP-ON
Serial Number.....................
Manufacturer...................... 0xbc00
Burned In MAC Address............. 0090.BC06.A571
System Object ID.................. 1.3.6.1.4.1.674.10895.3060
SOC Version....................... BCM56340_A0
HW Version........................ 5
CPLD Version...................... 20
Image File........................ N3000AdvLitev6.5.3.6
Software Capability............... Stack Limit = 8, VLAN Limit = 1024
unit active backup current-active next-active
---- ----------- ----------- -------------- --------------
1 6.5.3.6 6.5.3.6 6.5.3.6 6.5.3.6
2 6.5.3.6 6.5.3.6 6.5.3.6 6.5.3.6
3 6.5.3.6 6.5.3.6 6.5.3.6 6.5.3.6
4 6.5.3.6 6.5.3.6 6.5.3.6 6.5.3.6
How to setup mixed stack of N3000E-ON with N3132PX-ON Switches – Advanced Version
Dell EMC Networking
N3000E
-ON
switches can be mixed stack with N3132PX-ON switches of up to 12 units.
Dell EMC Networking N3132PX-ON switches has an expansion slot to install optional stacking module with two
mini-SAS stack ports. Dell EMC Networking
N3000E
-ON
switches are available with two fixed mini-SAS stack
ports.
Administrators setting up mixed stack of
N3000E-ON and N3132PX-ON Standalone switches
should follow the
below steps below:
1.
Back up your configuration of N3000E-ON and N3000 Switches.
2.
Upgrade using telnet or SSH require default enable authentication method or enable password in current
configuration. If not configured follow steps below to configure an enable password:
console#configure
console(config)#enable password <password>
console(config)#exit
console#copy running-config startup-config
3.
Download the 6.5.3.36 firmware image (N3000Advv6.5.3.36.stk) to N3000E-ON switch.
NOTE:
Activate the image to use as the boot (active) image after the switch
resets. Images on the N3000E-ON switch is named as active and backup.
Summary of Contents for EMC PowerSwitch N3000E-ON Series
Page 3: ......
