3. Using the Phillips #1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 106. Installing the M.2 SSD module
Next steps
1. If applicable,
Install the M.2 BOSS card into the M.2 BOSS riser
.
2. If applicable,
.
3. Follow the procedure listed in the
After working inside your system
on page 26.
Optional IDSDM module
Removing the IDSDM module
Prerequisites
1. Follow the safety guidelines listed in the
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
.
4. If you are replacing the IDSDM card, remove the MicroSD cards.
NOTE:
Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM card out of the system.
104
Installing and removing system components