Figure 87. Installing the R1 paddle card
Next steps
1. Connect the paddle card cables to the drive backplane
2. Insert the paddle card cable into the side wall bracket.
3.
If removed, install the air shroud
4. Follow the procedure listed in
After working inside your system
.
Intrusion switch module
This is a service technician replaceable part only.
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card riser
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Disconnect the intrusion switch cable from the connector on the rear I/O board.
2. Using a Phillips #2 screwdriver, loosen the screw on the intrusion switch module.
3. Slide the intrusion switch module out of the slot on the system.
106
Installing and removing system components
