Dell EMC PowerEdge C6520, Installation And Service Manual

Page: 51 / 89

M.2 SSD module
Removing the M.2 riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the air shroud .
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the riser to the chassis.
2. Holding the blue tag, lift the riser to disengage the riser from the connector on the system board.
3. Disconnect the SATA cable from the riser.
Figure 56. Removing the M.2 riser
Next steps
Replace the M.2 riser .
Installing the M.2 riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in Before working inside your system .
3. Remove the air shroud .
Installing and removing system components 51