Installing and removing system components
Topics:
•
•
Before working inside your system
•
After working inside your system
•
•
•
•
•
Expansion cards and expansion card risers
•
•
•
•
•
Processor and heat sink module
•
•
•
•
Safety instructions
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE:
It is recommended that you always use an antistatic mat and antistatic strap while working on components inside
the system.
NOTE:
While replacing faulty storage controller, FC, or NIC card with the same type of card, after you power on the
system; the new card automatically updates to the same firmware and configuration of the faulty one. For more information
about the Part replacement configuration, see the
Lifecycle Controller User's Guide
at
https://www.dell.com/idracmanuals
.
Before working inside your system
Prerequisites
Follow the safety guidelines listed in the
.
Steps
1. Power off the sled.
2. Remove the sled from the enclosure.
4
Installing and removing system components
23
