Figure 26. Installing the support bracket
Next steps
1.
Install the sled into the enclosure
.
2. Follow the procedure listed in
After working inside your system
.
Linking board and PCIe cable
Removing the linking board and PCIe cables
Prerequisites
NOTE:
Observe the routing of the cable as you remove it from the sled. Route the cable properly when you replace it to
prevent the cable from being pinched or crimped.
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4.
Steps
1. Press the release clip on the PCIe_A cable connector to disconnect the cable. See the
for more
information.
2. Press the release clip on the PCIe_B cable connector to disconnect the cable. See the
for more
information.
3. If connected, disconnect the SATA cable from the x16 M.2 riser.
4. Using the Phillips #1 screwdriver, loosen the captive screws on the linking board and lift the board up along with the cables.
Installing and removing enclosure components
37
