Removing and Replacing Parts
4-23
0LFURSURFHHDW6LQN$VVHPEO\
To remove or install a Celeron single-edge processor package (SEPP) or a
Pentium II single-edge contact (SEC) cartridge and heat sink, follow these
steps:
:$51,1* 7KH PLFURSURFHVVRU DQG KHDW VLQN DVVHPEO\ FDQ JHW
H[WUHPHO\ KRW GXULQJ V\VWHP RSHUDWLRQ %H VXUH WKDW WKH DVVHPEO\
KDV KDG VXIILFLHQW WLPH WR FRRO EHIRUH \RX WRXFK LW
:$51,1* :KHQ KDQGOLQJ WKH PLFURSURFHVVRU DQG KHDW VLQN DVVHP
EO\ WDNH FDUH WR DYRLG VKDUS HGJHV RQ WKH KHDW VLQN
1.
Remove the computer cover and support beam as described in “Computer
Cover and Support Beam.”
2. Remove the fan shroud by pressing its two tabs (see Figure 4-22) and gen-
tly lifting the shroud until it clears the fan and guide bracket assemblies.
Set the fan shroud aside.
)LJXUH 0LFURSURFHVVRU DQG +HDW 6LQN 5HPRYDO
3. For a Pentium II processor, press the SEC cartridge release latches until
they snap into place.
heat sink
SEPP
guide bracket
assembly
fan shroud
guide bracket assembly latch
fan assembly
fan shroud tabs (2)
SEC cartridge
SEC cartridge release latches (2)
