Dell C9000 series, Reference Manual

Page: 940 / 2286

Dell(config-if-range)# no shutdown
Dell(config-if-range)#
Example (Multiple
Range)
This example shows how to use commas to add VLAN and port-channel interfaces to
the range.
Dell(config-if)# interface range tengigabitethernet 2/1-23,
tengigabitethernet 1/1–2,
Vlan 2–100, Port 1–25
Dell(config-if-range)# no shutdown
Dell(config-if-range)#
Related
Commands
• interface port-channel — configures a port channel group.
• interface vlan — configures a VLAN interface.
• show config (from INTERFACE RANGE mode) — shows the bulk configuration
interfaces.
• show range — shows the bulk configuration ranges.
• interface range macro (define) — defines a macro for an interface-range.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
C9000 Series
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
interface,
interface,...
Enter the keywords
interface range
and one of the
interfaces — slot/port, pe-id/stack-unit/port-id, port-channel, or
VLAN number. Select the range of interfaces for bulk
configuration. You can enter up to six comma-separated ranges.
Spaces are not required between the commas. Comma-
separated ranges can include VLANs, port-channels, and
physical interfaces.
Slot/Port information must contain a space before and after the
dash. For example,
interface range tengigabitethernet
0/1 - 5
is valid;
interface range tengigabitethernet
0/1-5
is NOT valid.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
Interfaces 940