Dell C9000 series, Reference Manual

Page: 1020 / 2286

port-channel
number
Enter the keywords
port-channel
then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group — accesses PORT-CHANNEL FAILOVER-GROUP mode to
configure a LAG failover group.
show interfaces port-channel — displays information on configured Port Channel
groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing sixteen physical interfaces
on the switch.
C9000 Series
Syntax
interface port-channel channel-number
To delete a Port Channel, use the
no interface port-channel channel-number
command.
Parameters
channel-number For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
Interfaces 1020