Dell C9000 series, Reference Manual

Page: 929 / 2286

Related
Commands
• interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
• management route — configures a static route that points to the Management
interface or a forwarding router.
• speed (Management interface) — sets the speed on the Management interface.
flowcontrol
Enable and disable link-level flow control (802.3x pause frames) on an interface and (optionally) configure
buffer thresholds for pause and offset frame transmission.
C9000 Series
Syntax
flowcontrol rx {off | on} tx {off | on} [pause-threshold
{1-12480}] [resume-offset {1-12480}]
Parameters
rx on Enter the keywords
rx on
to process the received flow control
frames on this port.
rx off Enter the keywords
rx off
to ignore the received flow control
frames on this port.
tx on Enter the keywords
tx on
to send control frames from the port
to the connected device when a higher rate of traffic is received.
tx off Enter the keywords
tx off
so that flow control frames are not
sent from this port to the connected device when a higher rate
of traffic is received.
pause-threshold Enter the keyword
pause-threshold
to configure the buffer
threshold (in Kilobytes) at which the interface starts transmitting
pause frames for link-level flow control. Valid values are 1 to
12480KB. The default is 60KB.
resume-offset Enter the keyword
resume-offset
to configure the buffer
threshold (in Kilobytes) at which the interface resumes
transmitting offset frames for link-level flow control. Valid values
are 1 to 12480KB. The default is 9KB.
Defaults An interface ignores flow-control frames received from other network devices ( rx off )
and does not transmit pause frames ( tx off ).
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Interfaces 929