Dell C9000 series, Reference Manual

Page: 1009 / 2286

Version Description
8.3.1.0 Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information This command is found on the 10/100/1000/10000 Base-T Ethernet interfaces.
When you enable
auto
, the system performs an automatic discovery to determine the
optics installed and configure the appropriate speed.
When you configure a speed for the 10/100/1000/10000 interface, confirm the
negotiation auto command setting. Both sides of the link must have auto-negotiation
either enabled or disabled. For speed settings of 1000 or auto, the software sets the link
to auto-negotiation and you cannot change that setting.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a copper
SFP2 module with catalog number GP-SFP2-1T in the S25P model of the S-
Series, you can manually set its speed with the
speed
command. When you set
the speed to 10 or 100 Mbps , you can also use the
duplex
command.
If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10
Gigabit SFP+ port or 1 Gigabit SFP port. You can use the
speed
command to enable
the required speed.
speed (Management interface)
Set the speed for the Management interface.
C9000 Series
Syntax
speed {10 | 100 | auto}
To return to the default setting, use the
no speed {10 | 100}
command.
Parameters
10 Enter the keyword
10
to set the interface’s speed to 10 Mb/s.
100 Enter the keyword
100
to set the interface’s speed to 10/100
Mb/s.
auto Enter the keyword
auto
to set the interface to auto-negotiate
its speed.
Interfaces 1009