Installing the coin cell battery
1
Place the coin-cell battery into its slot on the system board.
2
Press the coin-cell battery with positive (+) side facing up until the release latch springs back into place and secures it to the system
board.
3
To install:
a
4
Follow the procedure in
After working inside your computer
.
System fan
Removing the System fan
1
Follow the procedure in
Before working inside your computer
.
2
Remove the:
a
b
c
d
e
3
To remove the system fan:
a Press the connector tab and disconnect the two fan cables from the system board.
NOTE:
Do not pull the connector by the cable wires. Instead, disconnect the cable by pulling on the connector end.
Pulling on the cable wires may loosen them from the connector.
40
Removing and installing components
Summary of Contents for 5820
Page 1: ...Dell Precision 5820 Tower Owner s Manual Regulatory Model D02T Regulatory Type D02T002 ...
Page 21: ...b Slide the slim ODD out of the system Removing and installing components 21 ...
Page 23: ...b Lift the bezel from the chassis Removing and installing components 23 ...
