The following image indicates the location of the thermal heat-sink and provides a visual representation of the installation
procedure.
Steps
1. Place the thermal heat-sink into its slot on the system board.
2. Align the screw holes on the thermal heat-sink to the screw holes on the system board.
3. Tighten the four captive screws to secure the thermal heat-sink to the system board.
NOTE:
Tighten the four captive screws in the sequential order mentioned on the thermal heat-sink [1 > 2 > 3 > 4]
Next steps
1. Install the
or the
, whichever applicable.
2. Install the
.
After working inside your computer
.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
Before working inside your computer
.
2. Remove the
.
3. Remove the
or the
, whichever applicable.
Removing and installing components
33
Summary of Contents for 3330
