Dell EMC Unisphere 360, Installation Manual

Page: 14 / 22

Installing Unisphere 360 on a Windows system
The default installation method for Windows is the wizard, but you can launch the
console mode using the following command:
UNISPHERE360_ version _WINDOWS_X86_64.exe -i console
To install Unisphere 360:
Procedure
1. To run the installer, double click the executable file.
2. In the Introduction page, click Next.
3. In the Choose Install Folder page, do one of the following:
l
In the Where Would You Like to Install field, type the installation path.
l
Click Choose and navigate to the installation path.
4. Click Next.
5. In the Ports Configuration page, do the following:
a. In the HTTPS Port No field, type the HTTPS port number, or accept the
default value of 8470.
b. In the DB Port No field, type the database port number, or accept the
default value of 3424.
c. Click Next.
6. In the X.509 Certificate-based Client Authentication page, do one of the
following:
Note
Enable X.509 certificate-based authentication only if it is enabled on the
Unisphere for PowerMax instance. Otherwise, enrollment of the Unisphere for
PowerMax instance will fail.
l
To continue installing without configuring X.509 certificate-based
authentication, click Next.
l
To configure X.509 certificate-based authentication, complete the following
steps:
a. Select Enable certificate based client authentication.
b. Specify whether to use the CN or UPN of the client's identify.
Note that instances of the following special characters are stripped from
the alias: @:?;|<>[]+=,*/\
c. In the Admin User Name field, specify the admin user name.
The admin user name must match CN/UPN of the X.509 certificate
(minus any special characters that are stripped out) as configured in step
6.b on page 14.
This user is created in Unisphere 360 and assigned administration
privileges to bootstrap administration of the system.
d. Click Next.
Installing Unisphere 360
14 Dell EMC Unisphere 360 9.0.1 Installation Guide