後續步驟
1. Replace the cable retention bracket. See Installing the cable retention bracket section in this document.
2. Complete the tasks listed in After working inside your system section in this document.
相關工作
Before working inside your system
After working inside your system
Installing the cable retention bracket
相關參考
Installing the cable retention bracket
事前準備作業
1. Ensure that you read the Safety instructions section in this document.
2. Complete the tasks listed in Before working inside your system section in this document.
3. Remove the cooling shroud.
4. Remove the PCIe card holder.
警示
:
許多維修僅可由獲得認可的維修技術人員來完成。
您
只能依照
產
品說明文件中的授權說明或在線上或電話服務和支援團隊
的指導下，執行故障排除和簡單的維修。由未經
Dell
授權的維修造成的損壞不在保固範圍之內。請閱讀並遵循隨
產
品寄送的安
全指示。
步驟
1. Align the cable retention bracket with the alignment pins on the chassis.
2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the slots.
3. Place all cables to be routed in the cable retention bracket.
後續步驟
1. Install the PCIe card holder.
2. Install the cooling shroud.
3. Complete the tasks listed in After working inside your system section in this document.
相關工作
Before working inside your system
After working inside your system
相關參考
Power supply units
Your system supports one of the following:
•
Two 750 W, or 1100 W AC PSU modules or
•
Two 1100 W DC power supply modules or
•
Two 750 W mixed mode PSU modules
註
:
Titanium PSU is nominally rated for 200 V AC to 240 V AC input only.
註
:
When two identical PSUs are installed, PSU redundancy (1+1 – with redundancy or 2+0 – without redundancy) is
configured in system BIOS. In redundant mode, power is supplied to the system equally from both PSUs when the Hot
Installing and removing system components
93
