Next steps
Replace the power interposer board
.
Installing the power interposer board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
Steps
Insert the power interposer board into the guides and then lower it until the plunger click into place.
Figure 121. Power interposer board installation
Next steps
1. Install the
2. Reconnect all the cable that were removed.
3. Follow the procedure listed in
After working inside your system
System board
Removing the system board
Prerequisites
CAUTION:
If you are using the Trusted Platform Module (TPM) with an encryption key, you may be prompted to create
a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
3. Remove the following components:
a.
144
Installing and removing system components
