Removing a power supply unit
Prerequisites
CAUTION:
The system requires one power supply unit (PSU) for normal operation. On power-redundant systems,
remove and replace only one PSU at a time in a system that is powered on.
1. Follow the safety guidelines listed in the
2. If installed,
3. Disconnect the power cable from the power outlet and from the PSU you intend to remove.
4. Remove the cable from the strap on the PSU handle.
Steps
Press the release latch, and holding the PSU handle slide the PSU out of the PSU bay.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 45. Removing a power supply unit
Next steps
Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
3. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum output
power.
NOTE:
The maximum output power (shown in watts) is listed on the PSU label.
4.
.
Steps
Slide the PSU into the PSU bay until the release latch snaps into place.
70
Installing and removing system components