Figure 120. Installing a power supply unit
Next steps
1. If you have unlatched the cable management arm, relatch it. For information about the cable management arm, see the system’s rack
documentation at
.
2. Connect the power cable to the PSU, and plug the cable into a power outlet.
NOTE:
When connecting the power cable to the PSU, secure the cable to the PSU with the strap.
NOTE:
When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the
PSU and determine its status. The PSU redundancy may not occur until discovery is complete. The PSU status
indicator turns green to indicate that the PSU is functioning properly.
NOTE:
While replacing the hot swappable PSU, after next server boot; the new PSU automatically updates to the
same firmware and configuration of the replaced one. For more information about the Part replacement
configuration, see the
Lifecycle Controller User's Guide
https://www.dell.com/idracmanuals
Installing a power supply unit blank
Prerequisites
1. Follow the safety guidelines listed in the
2.
Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
130
Installing and removing system components
