Dell EMC P44E, Service Manual

Page: 43 / 103

4. Place the memory shield and slide it towards the left side of the computer to cover the memory module.
5. Replace the (M2x3) screw to secure the memory shield to the memory module.
Next steps
1. Install the keyboard .
2. Install the keyboard lattice .
3. Install the battery .
4. Install the base cover .
5. Install the SD card .
6. Follow the procedure in after working inside your computer .
Hűtőborda-
Removing the heat-sink assembly
Prerequisites
1. Follow the procedure in before working inside your computer .
2. Remove the SD card .
3. Remove the base cover .
4. Remove the battery .
About this task
The figure indicates the location of the heat-sink assembly and provides a visual representation of the removal procedure.
Steps
1. Peel the power-adapter cable from the heat-sink assembly.
2. Disconnect the two fan cables from the connectors on the system board.
3. Loosen the eight captive screws that secure the heat-sink assembly to the system board.
NOTE: Loosen the captive screws in the order stamped onto the heat-sink assembly next to the screws [1 > 2 > 3 > 4
> 5 > 6 > 7 > 8].
Szétszerelés és újbóli összeszerelés 43