Dell EMC FS25, Field Replacement Unit Manual

Page: 35 / 50

Removing the front bezel
About this task
NOTICE You must remove the disk enclosure’s front bezel to gain access to the disks. The
bezel is required for EMI compliance when the enclosure is powered up. Remove it only to
replace or add a disk.
Refer to Figure 21 on page 35 while performing the procedure that follows.
Procedure
1. If the bezel has a lock, insert the key that shipped with your enclosure into the lock, and turn
the key to unlock the bezel.
2. Press the two latch buttons on the bezel surface to release the bezel from the cabinet.
3. Pull the bezel off the cabinet and put it on a clean, static-free surface.
Figure 21 Removing the front bezel
CL5261
Removing the DAE from the cabinet
About this task
NOTICE Do NOT remove components such as disks, LCCs, or power/cooling modules from the
faulted DAE before removing the chassis from the cabinet. Doing so greatly increases the risk
of returning a component to the wrong slot in the replacement chassis, which can result in
data loss.
CAUTION
The enclosure is heavy and should be installed into or removed from a rack by two people. To
avoid personal injury and/or damage to the equipment, do not attempt to lift and install the
enclosure into a rack without a mechanical lift and/or help from another person.
L'enclosure étant lourde, sa mise en place dans l'armoire nécessite deux personnes. Afin de ne
pas vous blesser et/ou endommager le matériel, n’essayez pas de soulever et d’installer
l’armoire sur une rampe sans avoir recours à un relevage mécanique et/ou à l’aide d’une autre
personne.
Replacing a 25-Slot Disk-Array Enclosure
Dell EMC FS25 SSD Shelf Guide Field Replacement Unit Guide 35