3. Tighten the (M2x3) captive screw and replace the four (M2x3) screws to secure the system board to the chassis.
4. Route the power-button cable and the coin-cell battery cable through the routing guides.
5. Connect the power-button cable and the coin-cell battery cable to the connectors on the system board.
6. Route the WLAN antenna cables through the routing guides.
NOTE:
The antennas should be aligned with the notches in the system board and the cable routing should not be over
the system board QR code.
Next steps
1. Install the
2. Install the
.
3. Install the
.
4. Install the
.
5. Install the
.
6. Install the
.
.
Heat-sink
Removing the heat-sink
Prerequisites
before working inside your device
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
.
7. Remove the
.
8. Remove the
About this task
The figure indicates the location of the heat-sink assembly and provides a visual representation of the removal procedure.
Removing and installing components
41