Delfield Convochill T14D, Service, Installation And Care Manual

Page: 19 / 44

Input SW2 (ALL 05) (door microswitch alarm)
Cause:
Input active for more than 5 minutes with appliance in start status.
Door open (close door) Microswitch fault (replace the microswitch)
Beeper: Activated (3 seconds, then a pause of 30 seconds) until the mute button is pressed.
Display:
Alternates message “ALL 05” with standard display
Reset:
Press the mute push-button (with beeper off).
Automatically resets if input value returns to normal Alternatively, switch off the panel
then turn it back on (stand-by).
Input SW1 alarm (ALL 06) (T5 and T14D models only)
(High pressure switch) for all models
(Compressor thermal-magnetic switch) if installed
(Oil diff. pressure switch) if installed
Cause:
Input active for more than 5 seconds
Effect: Sets the appliance to STOP.
Reset the max. pressure switch, thermal-magnetic switch or differential pressure switch.
Beeper:
Activated (3 seconds, then a pause of 30 seconds) until the mute button is pressed.
Display: Alternates message “ALL 06” with standard display
Reset:
Press the mute push-button (with beeper off) with no alarm cause displayed
Input SW3 alarm (ALL 08)
(Kriwan compressor automatic reset) only for T14D
(Thermostat on the discharge line)
Cause:
Input active for more than five seconds at least three times when appliance is in start mode
Effect: Compressor shuts down and resumes operation when input value returns to normal.
The appliance sets to STOP at third alarm.
Beeper:
Activated (3 seconds, then a pause of 30 seconds) until the mute button is pressed.
Display/Led: Alternates message “ALL 08” with standard display
Reset:
Press the mute push-button (with beeper off).
Alternatively, switch off the panel then turn it back on (stand-by).
Input Ht1 alarm (ALL 09) (Input in voltage 1 ... fuses).
Input Ht2 alarm (ALL 10) (Input in voltage 2 ... fuses)